pH Electrode Accessories
Hach Company Hach Cartrical Sensor Cartridge for AN-ISE sc / A-ISE sc / N-ISE sc
Replacement sensor cartridge designed for AN-ISE sc, A-ISE sc, and N-ISE sc probes. The cartridge contains calibrated ion-selective electrodes for ammonium and potassium, a reference system, and a temperature sensor. It is factory calibrated and RFID-enabled to minimize maintenance and allow immediate operation after replacement.
- Replacement cartridge for ammonium and potassium ion-selective electrode probes.
- Contains calibrated electrodes, reference system, and temperature sensor in a compact housing.
- Factory calibrated and RFID-enabled for automatic recognition after replacement.
- Simple replacement procedure requires unscrewing the old cartridge and plugging in the new one.
- Typical service life of approximately 6 months.
Hach Company Replacement Sensor for CLT10sc
Replacement Sensor for CLT10 sc Total Chlorine Analyzer Stainless Steel Tip
Grainger pH Electrode Epoxy BNC Round Tip
The Grainger Approved pH Electrode is a combination electrode designed for general purpose pH measurement in the 0-14 pH range. It has a glass body, gel-filled reference with Ag/AgCl reference wire, BNC connector, and epoxy body. The electrode has a response time of less than 10 seconds and is compatible with pH meters that accept BNC connectors. It requires storage solution and regular calibration for accurate pH readings. The electrode measures 12" length x 0.5" diameter.
Hach Company LCP Salt Bridge, Qty: 1
Field replaceable salt bridge has a ceramic inner junction, PVDF outer junction, Viton O-Ring, and contains binary fill solution. Only for use with LCP 1-1/2 Inch differential pH sensors.
Grainger pH Electrode Epoxy BNC Round Tip
The Grainger Approved pH Electrode is a combination electrode designed for general purpose pH measurement. It has a glass body, epoxy body material, gel electrolyte, and a BNC connector. The electrode has a pH range of 0-14 pH, is compatible with aqueous solutions, and has a temperature range of 0-80°C. The electrode has a 12 mm diameter x 120 mm length. It should be stored in pH 4 buffer solution.
Grainger Replacement Electrolyte CLD
The SENSOREX CLDA-4015 is a replacement electrolyte solution for SENSOREX chlorine dioxide analyzers. It is used to refill electrolyte cells in CLDA Series chlorine dioxide analyzers after the initial fill has been depleted. This 500 mL bottle of electrolyte solution is manufactured by SENSOREX to properly replenish electrolyte cells in their chlorine dioxide measurement equipment. The electrolyte solution enables accurate measurement of chlorine dioxide levels in water treatment applications. It has an operating temperature range of 32-122°F.